Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 177 / 200

7935 Stereo Input Motor fader 8-5
Revision J2005-2 J-Type
Aux VCA ‘off’: If any of the Aux Sends on a channel are set to send signal post-fader,
the channel fader will directly control the signal level sent to the Aux mix bus. A DC
master selected for the channel fader or the faders Mute will have no effect.
Aux VCA ‘on’: If any of the Aux Sends are set to send signal post-fader and a DC
Master fader is selected for the channel fader, the DC Master fader will control the
overall of the signal to the Aux mix bus in addition to the channel fader level.
;1517 *URXS # VHOHFWLRQ
Press the (+) button to increment the DC Master group number and the (-) button to
decrement the DC Master group number. The DC Master group number selected is
shown on the hexadecimal display above the switches. This can also be pro-
grammed as part of a cue.
;1518 ,VRODWH
When this button is pressed, the fader is disconnected from the computer system. It
cannot send commands to the computer and it cannot receive commands from the
computer.
All faders can be put in isolate mode by pressing the ALL FADER ISOLATE “SET”
SWITCH on the master fader control panel below the CCM module. Similarly, all fad-
ers can be taken out of isolate mode by pressing the ALL FADER ISOLATE “CLEAR”
switch on the same panel.
;1519 :ULWH
If the fader is in READY mode, then as soon as the fader knob is touched, this LED
comes on and dynamic data is sent to the PC. The fader will no longer respond to
movements sent by the PC.
;151: 5HDG\
This LED indicates that fader data can be sent to the PC. However no data will be
sent until the Write mode is invoked by touching the fader knob. The fader will in this
state respond to movement commands from the PC.
;151; 6DIH
This LED indicates ‘safe’ mode. No dynamic data will be sent to the PC. The fader
will respond to movement commands from the PC.
;151< %\ 0 SDVV
When this button is pressed, the fader behaves as if it is a manual device with no
VCA grouping. Data may, however, be sent to or received from the computer, but
cannot be used until the By-pass mode is switched ‘off’. Please note that although
the data is saved and recalled, the fader position is not acted upon.
All faders can be put in By-pass by pressing the ALL FADERS BY-PASS “SET” switch
on the master fader control panel below the CCM module. Similarly, all faders can be
taken out of By-pass mode b pressing the ALL FADER BY-PASS “CLEAR” switch on
the same panel.