BYD TANG EV 2021, Руководство пользователя, Страница: 193 / 218

192
REMINDER
•
The tyre sealant should be shaken
thoroughly before use.
4. Screw the inflator pump connector into
the tyre valve.
5. Plug the power plug into the on-board
power supply port.
6. Start the vehicle.
7. Power on the inflator pump and start the
tyre repair.
8. Read the tyre pressure gauge on the
inflator pump.
REMINDER
•
If the tyre pressure is between 180-
320kPa, remove the inflator pump
power plug at once. Within 1 minute,
drive the vehicle for no more than 10
km at a speed below 80 km/h to allow
the sealant to be distributed evenly
inside the tyre.
• If the tyre pressure does not reach
180 kPa within 10 minutes, turn off
the inflator pump and contact a BYD
authorised dealer or service provider.
9. After tyre repair, drive the vehicle for a
short period of time and then stop to
check the tyre pressure again.
• If the tyre pressure is greater than 220
kPa, drive at a speed below 80 km/h
to the nearest service provider.
•
If the tyre pressure is between 130-
220kPa, inject the tyre sealant into the
tyre and read the tyre pressure gauge
on the inflator pump again.
•
If the tyre pressure does not reach 130
kPa, contact a BYD authorised dealer
or service provider.
CAUTION!
•
Repairing a damaged tyre with
the tyre sealant kit is a temporary
solution for emergencies only.
Contact a BYD authorised dealer or
service provider to replace the tyre as
soon as possible. Be sure to inform
maintenance technicians that the tyre
has sealant inside.
• Avoid sudden acceleration or turning
at high speeds.
• Do not exceed 80 km/h. Stop driving if
any strong vibrations, unstable driving
performance or noise appears when
the vehicle is running.
•
Replace any tyre sealant that is about
to expire (refer to the label on the
canister for the expiration date).
•
After repairing a tyre with the tyre
sealant kit, it is recommended that
a new one is purchased from a BYD
authorised dealer or service provider.
Jump Start
When the vehicle won't start due to low 12V
battery (starter Fe battery), try to start it as
below:
1. Open the bonnet. (Refer to
Maintenance
- Refilling Oil - Opening and Closing
the Bonnet )
2. Remove the bonnet left trimming.
3. Connect one end of the red anode (+)
cable to rescued vehicle 12V battery
(starter Fe battery) anode (+) terminal.