Bull ESCALA E250, Использование и обслуживание, Страница: 45 / 162

3-5
Using Devices and Tools
Loading the CD-ROM
1. Press the unload button to open the disk tray. The disk tray slides out far enough to put
in the disk. The disk holders are used to secure the disk into the tray.
Notes:
a. If the CD-ROM is used with the disk not set properly, the disk and the laser lens may
be damaged. Be sure to set the disk properly and use the device correctly.
b. Depending on the CD-ROM device model you are using, you may have either three
or four disk holders. The procedures used to load or unload the disk are the same.
c. Always handle the disk by the edge to avoid fingerprints and scratches that could
affect the readability of the data stored on the disk.
2. Put the disk on the tray.
3. Gently push the tray. The tray slides into the drive and the disk is ready for reading.
Unloading the CD-ROM
Note:
Always handle the disk by the edge to avoid fingerprints and scratches that could
affect the readability of the data stored on the disk.
1. Push the unload button to open the disk tray.
2. Release the projections and gently pull the disk out of the holder.
3. Slide the disk upward and store it in its protective case.
Handling CD-ROM’s
When you are using the CD-ROM, the following recommendations should be considered:
• Keep CD-ROM’s in their protective case when they are not in use
• Do not touch the surface of a CD-ROM, handle a CD-ROM by its edges only
• Do not store CD-ROM’s in dusty, smoky, or salty areas
• Do not subject CD-ROM’s to sudden temperature changes, which may cause
condensation to damage them
• Do not expose CD-ROM’s to heat, direct sunlight, strong magnetism or corrosive gas.
Cleaning the CD-ROM Drive
The drive optics can be cleaned using an audio CD lens cleaner.