Bull ESCALA E250, Использование и обслуживание, Страница: 121 / 162

6-19
Expanding the System Configuration
Device Upgrading
•
Media Drive Installation , below
• Hard Disk Drive Installation , on page 6-23
• Media Drive Removal , on page 6-27
• Hard Disk Drive Removal , on page 6-30
• Device Hot Swapping , on page 6-33
• Adding a Disk Expansion Unit , on page 6-35.
Media Drive Installation
Warning:
Before handling any device, be sure you know the rules described in
Device
Configuration , on page 5-7.
1. Perform a system power off and unplug the unit power cord from the wall outlet (for
details, if needed, see Preliminary Operations , on page 6-3).
2. Remove the front panel and the right lateral panel (for details, if needed, see Front
Panel Removal , on page 6-6 and Lateral Panel Removal , on page 6-7).
3. Wear the antistatic wrist strap. It is recommended not to touch the components on the
device back panel (for details, if needed, see How to Handle Hardware Components ,
on page 6-2).
Note: The figures in this section illustrate a CD-ROM drive. The procedures apply to any
media drive model.
4. Remove the metal blank from the designated slot by loosening the screws used to retain
the blank to the chassis.
Warning: It is recommended to store the metal blank and screws for possible future
re-installation.
5. Set the SCSI-ID of the media drive, as described in Media Drive SCSI-ID , on page 5-10.
6. Install the SCSI adapter on the SCSI connector of the media drive. This SCSI adapter is
needed to adapt the SCSI connector of the media drive to the connector present on the
SCSI cable.