Bruker BMPC/2, Техническое руководство

Страница: 72 / 136

72 Z31823_00_05
Troubleshooting
11.1.1.11 Resistor Initialization Failed
It was not possible to read the data for the heater resistors H1 and H2 from the EEProm.
For the calculation of the heater power, the default values are used (100 Ohm), therefore
the calculation may be wrong.
Solution:
Reenter the data for the heater resistor using the menu
Tools - Options - Hea-
ter & APD Setting
.
11.1.1.12 APD Initialization Failed
It was not possible to read the configuration data for the absolute pressure device (APD)
from the EEProm, thus the pressure regulation via the APD could not be started.
Solution:
Reenter the data for the heater resistor using the menu
Tools - Options - Hea-
ter & APD Setting
.
11.1.1.13 Heater Regulation Initialization Failed
The parameters for the pressure regulation using the heater H1 could not be read from
the EEProm, thus the default data was loaded. This data may not be optimal for your
type of magnet, and therefore the pressure regulation may be imprecise.
11.1.1.14 Warning, Power Supply GS1 failed
The power supply GS1 in the BMPC/2 Line Control Unit failed.
Solution:
The redundant power supply GS2 has taken over the function of GS1. Please
check the GS1 fuse as shown in section "Exchanging the GS1 or GS2 Power Supply
Fuses" on page 85
.
If this does not solve the problem the power supply GS1 must be
replaced with a new one. Please contact your local Bruker Service department.
The Bruker part number for this power supply is:
87491
.
11.1.1.15 Warning, Power Supply GS2 failed
The power supply GS2 in the BMPC/2 Line Control Unit failed.
Solution:
The redundant power supply GS1 has taken over the function of GS2. Please
check the GS2 fuse as shown in section "Exchanging the GS1 or GS2 Power Supply
Fuses" on page 85
.
If this does not solve the problem the power supply GS2 must be
replaced with a new one. Please contact your local Bruker Service department.
The Bruker part number for this power supply is:
87491
.