Bruker BMPC/2, Техническое руководство

Страница: 88 / 136

88 Z31823_00_05
Configuration (administrator)
1. Select your magnet from the pull-down list.
2. Enter the temperature measuring resistance for T1 and T2. The limit data is then
calculated automatically.
3. Press the
Next
button to continue to the next magnet setup step.
Figure 12.2 Magnet Setup Step 2
4. Enter the setpoint for pressure value P2. The correct setting depends on the height
above sea level where the magnet is installed.
Alternatively, to calculate the P2 heater setpoint, enter the height value in the field
provided press the
Calculate Setpoint
button.
The setpoint is the pressure that is to be reached with the help of the heating regu-
lator.
The P2 APD value will be calculated automatically.
5. Enter the resistance values for the two heating resistors. These are usually 100
Ohms. More detailed information can be found in the magnet manual.
6. Press the
Next/Write Values
button to assume the configuration data.
7. When prompted, confirm that the configuration is correct by pressing
Yes
, or
No
if
you need to revise the data.
Setpoint for P2
Resistance Value
for Heater 1 and
for Heater 2