Brother GT-3 Series, Руководство по обслуживанию

Страница: 228 / 375

6. Replacing Parts
Assembling
1.
Mount the Ink Cartridge Base Unit on the printer in the reverse process of the step 9 in “Disassembling”.
2.
Follow the reverse process of the step 5-8 in “Disassembling”, connect the Tubes with the Needles, and
connect the Harness: Ink MNT, and mount the two Tube Holder Fixes and the Clamps NK-18N.
3.
Connect the Tubes with the Needles by referring to “6-1-36. Needles”.
4.
Mount the Carriage Front Cover and Guard Bar in the reverse process of the steps 3 and 4 in
“Disassembling”. Remove all the Filter Cartridges from the Ink Cartridge Base Unit and mount the
Cartridge Front Cover. Then insert the Filter Cartridges again.
5.
Mount the Cover Cartridge. (Refer to “6-1-2. Assembling/Disassembling of the Covers”.)
Confirmation
1.
Confirm the Ink Switch that you replaced. See the example “W2”:
(1) Turn ON the printer.
(2)
Remove the Filter Cartridge W2 by 5 cm and confirm the Panel if it is indicated as [Error: No Ink W2].
2.
Insert the Filter Cartridge to the end and confirm it the error above disappears.
3.
Load the Ink inside the Tubes. The process is different between the Color Ink and the White Ink. Follow
the process in “2-6-2. Installing Ink”. Prepare the Maintenance Cartridge W and Maintenance Solution for
White Ink.
4.
When all the inks are filled with the Tubes, print the Nozzle Check Pattern to confirm the print quality.
(Refer to “2-6-3. Test Print”).
GT-3 Series
219