Brother GT-3 Series, Руководство по обслуживанию

Страница: 241 / 375

6. Replacing Parts
6-1-35. Tubes
0195Y
<Note>
・
Take care not to bend or crush the Tubes; they are very fragile, especially a new Tube. Handle with care
and keep the minimum bending radius by 50 mm or more.
・
Replace to a new Tube if bent or damaged.
・
Open the Caps of the Maintenance Unit to move down the Carriage by hand, otherwise the Print Head
may be seriously damaged.
・
The surface of Print Heads will be dried and clogged in operation because they have to be left with
"cap-open". Operate as quickly as you can, and be sure to cap them again on the Maintenance Unit and
do head cleaning after operation.
・
Move the Wiper back and forth to wet the surface of the Print Head Nozzles, to protect Print Heads from
clogging. Better to operate in higher humidity.
・
Dirt or dust produced during work may result in Print Head malfunction, and therefore due care should be
exercised.
・
Take a photo first before you replace, so that you can check the layout later.
・
Cap the protection cap at both ends of the Tube after all the operation is finished to keep the inside clean.
Pay maximum attention not to put dust or dirt into the Tubes. Handle with care not to let you wet with Ink
and Maintenance Solution running out from the Tubes. Cover the edge of the Tubes with the Caps listed
below:
VRSP6 VRFP6
・
For covering:
Tube Joint 2 *VRFP6 (SA5905) (1)
Tube Joint VRSP6 (SB0644) (2)
<Note>
Wash the ink and dust and flush with distilled water before you re-use the Tube Joints. Keep away from the
dust in storage.
GT-3 Series
232