Brother GT-3 Series, Руководство по обслуживанию

Страница: 111 / 375

4. Solving Print Quality Problems
4.
Lift up the bottom of the bottle, and rotate it by three times to rinse the top and the side of the bottle.
4727M
5.
Throw away the Maintenance Solution from the bottle.
6.
Fill the Maintenance Solution into the bottle for Tube Cleaning. Pay attention not to put dust inside the
cleaned bottle.
<Note> Keep the 250 ml of Maintenance Solution inside the bottle to execute Tube Cleaning for one print
head.
7.
Execute White/Color Tube Cleaning. See the sequence below.
8.
After the Tube Cleaning is done, keep the bottle in a clean condition; Cover it with a clean bag (polyester)
from the top.
A. White Tube Cleaning (Once a week)
<Note>
Confirm the firmware should be ver. 2.10 or higher.
This menu washes away the pigments inside the Tubes and Print Heads. When you execute this menu
all-in-one time, GT-381 for four Tubes, GT-361 for two Tubes, you can retrieve the White Ink before Tube
Cleaning. It takes time but you can save the cost. If you select the Tube one by one then the White Ink will not
be retrieved. Follow the indications on the Display and operate with Maintenance Cartridge.
<Note>
If you leave GT-3 printer unused for more than two weeks, execute White Tube Cleaning for storage. Insert
Capping Cartridges (option) in place of White Ink Cartridge. See "7-2. Required Maintenance for the Long
Storage".
All Whites Tube Cleaning
Sequence of All Whites Tube Cleaning (firmware ver. 2.10 or higher)
102
GT-3 Series
<Note>
If you execute Tube Cleaning one by one, then the first "Retrieving White Ink" is skipped.
Insert Capping Cartridges (option) in place of White Ink Cartridge when you leave the GT-3 printer unused for
more than two weeks.
1.
Fill the bottle with Maintenance Solution. Confirm that at least more than 250 ml per one Print Head is in
the bottle.
2.
Confirm in advance the amount of the Waste Ink in the Waste Ink Tank (more than 500 ml).
3.
Confirm that the printer is either [ Standby ] or [ Ready ].
4.
Select [ Maintenance ] > [ White Tube Cleaning ] from the menu and press OK Button.
5.
Select [ All Whites ] then White Ink retrieval starts and the countdown is indicated on the Display. Please
wait until the retrieval finishes (4 minutes).
All Whites
：
Retrieving
White Ink
Repeats the steps four times for GT-381(W1-W4), two times for GT-361 (W1, W2)
Set Maintenance
Cartridge
Tube
Cleaning
Insert White Ink
Cartridge or Capping
Cartridge
Set Filter
Cartridge
Load Mainte-
nance Solution