Brother GT-3 Series, Руководство по обслуживанию

Страница: 315 / 375

6. Replacing Parts
4.
Remove all the Needle Felts (2) one by one from the Needles.
1)
Take the edge of the Needle Felt with Tweezers (photo A).
2)
Add a cut (a) with scissors on the Felt (photo B and C).
3)
Pluck all the Needle Felt with Tweezers (photo D).
<Note>
Do not pull out the Needle Felt (12) from the tip of the Needle; the small fiber may go into the Needle and
give damage to the Print Head.
(2)
(a)
C
A B
4)
Remove those remained ink (b) and the double-sided adhesive tape (c) as shown in the photo
D with the Clean Stick (d) with Maintenance Solution applied (see photo E) to make them clean
as shown in the photo F.
<Note>
Use the Mirror to confirm if the Needle should be clean.
(b)
(c)
(d)
F D E
5.
Confirm if all the Needles are clean with no Needle Felts remained, then agitate the White Ink Cartridges
and load the Ink inside the Tubes. Follow the steps 11-14 in the Process 1.
GT-3 Series
306