British Leyland Triumph Toledo, Руководство по ремонту

Страница: 93 / 339

FUEL SYSTEM
15. Unscrew and remove the lever pivot bolt and
spacer.
16. Detach the lever assembly and return springs, noting
the pivot bolt tubes, skid washer and the locations
of the cam and pick-up lever springs.
17. Remove the float-chamber securing bolt and the
chamber.
18. Mark the float-chamber lid location.
19. Remove the lid securing screws and detach the lid
with its joint washer and float.
20. Hold the float hinge pin at its serrated end and
withdraw the pin and float.
21. Extract the float needle from its seating and unscrew
the seating from the lid.
22. Close the throttle and mark the relative position of
the throttle disc and the carburetter flange.
CAUTION: Do not mark the throttle disc in the
vicinity of the limit valve.
23. Unscrew the disc retaining screws, open the throttle
and ease the disc from its slot in the throttle spindle.
Store the disc in a safe place until required for
assembly.
24. Tap back the tabs of the lock washer securing the
spindle nut; remove the nut and detach the lever
arm, washer and throttle spindle; note the location
of the lever arm in relation to the spindle and
carburetter body.
Inspecting
25. Examine the components as follows:
a. Check the throttle spindle in the body for
excessive play, and renew if necessary.
** b. Examine the float needle for wear, i.e. small
ridges or grooves in the seat of the needle, and
ensure that the spring-loaded plunger on the
opposite end operates freely. Replace the needle
and seating if necessary.
c. Inspect all other components for wear and
damage; renew unserviceable components.**
continued
If
10------ ---
Triumph Toledo Manual. Part N o. 545168. Issue 2
19.15.17 Sheet 2
19.15.18 Sheet 2