Boss Snowplow Snowrator SNR24001, Руководство пользователя

Страница: 25 / 48

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Important:
Refer to your engine owner’s manual for additional maintenance procedures.
WARNING
Failing to properly maintain the machine could result in premature failure of machine systems,
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
CAUTION
If you leave the kill cord connected to the operator presence sensor or the key in the switch,
someone could accidently start the engine and seriously injure you or other bystanders.
Disconnect the kill cord from the operator presence sensor and remove the key from the
switch before you perform any maintenance.
Maintenance Safety
•
Before adjusting, cleaning, servicing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the motion-control levers to the N
EUTRAL
position.
– Disconnect the kill cord from the operator
presence sensor to shut off the engine.
– Wait for all moving parts to stop.
– Remove the key.
– Disconnect the spark-plug wire.
– Close the fuel-shutoff valve.
– Allow machine components to cool before
performing maintenance.
•
Ensure that only trained personnel install and
perform maintenance on the equipment and
hydraulic components.
•
Do not fill, calibrate, or clean the machine while
people, especially children, or pets are in the area.
•
Keep your hands and feet away from moving
parts. If possible, do not make adjustments with
the engine running.
•
Carefully release pressure from components with
stored energy.
•
Check all fasteners at frequent intervals for proper
tightness to ensure that the machine is in safe
working condition.
•
Never tamper with safety devices. Check their
proper operation regularly.
•
Clean up oil or fuel spills.
•
Do not rely on a hydraulic system to support the
machine; support the machine with jack stands
whenever you raise the machine.
•
Keep all parts in good working condition and all
hydraulic fittings tight. Replace all worn, damaged,
or missing parts and decals. Keep all fasteners
tight to ensure that the machine is in safe working
condition.
•
To ensure optimum performance and continued
safety of the machine, use only genuine
BOSS replacement parts and accessories.
Replacement parts and accessories made by
other manufacturers could be dangerous, and
such use could void the product warranty.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 20 hours
• Change the engine oil.
After the first 50 hours
• Change the hydraulic filters and hydraulic fluid.
25