Boss Snowplow Snowrator SNR24001, Руководство пользователя

Страница: 42 / 48

15. Install the spark plug but do not connect the wire
to the spark plug; refer to
Installing the Spark
Plug (page 32) .
16. Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
17. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
18. Loosen the trip-return springs.
19. Store the machine in a clean, dry, garage or
storage area. Remove the key from the engine
key switch and store it in a memorable place.
Cover the machine to protect it and keep it clean.
Removing the Machine
from Storage
1. Check the plow for cracked welds.
2. Check the torque of all fasteners; tighten as
necessary.
3. Check the hydraulic lines and hoses for cracks
or leaks.
4. Replace the hydraulic fluid; refer to Adding
Hydraulic Fluid (page 38) .
5. Check the plow cutting edge for wear.
6. Tighten the trip-return springs until there is a gap
of 0.8 mm (1/32 inch) between the trip spring
coils.
7. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
8. Apply dielectric grease to all of the wire harness
connectors.
9. Connect the spark plug wire.
10. Move the plow through its range of motion to
check the hydraulic cylinder rods.
42