Boss Snowplow Snowrator SNR24001, Руководство пользователя

Страница: 38 / 48

g294713
Figure 49
1. Hydraulic filter hose fitting 2. Hydraulic pump
4. Disconnect the hose.
5. Allow the hydraulic fluid to fully drain from the
machine.
6. Connect the previously disconnected hose to
the hydraulic pump.
7. Remove the hydraulic filter ( Figure 50 ).
g294714
Figure 50
1. Hydraulic filter
8. Install a new hydraulic filter.
Adding Hydraulic Fluid
1. Clean the area around the hydraulic-reservoir
cap.
2. Remove the hydraulic-tank cap ( Figure 51 ).
g294667
Figure 51
1. Hydraulic tank cap 2. Hydraulic tank filler neck
3. Slowly add fluid to the hydraulic tank until it is
approximately 2/3 full.
Important:
Use the fluid specified in
Hydraulic System Specifications (page 37) .
Other fluids could cause system damage.
4. Install the hydraulic-tank cap.
5. Raise the machine so all 4 wheels are off of the
ground and support the frame with jack stands.
6. Start the engine and run the wheels forward and
backward for at least 2 minutes.
7. Shut off the engine and lower the machine to
the ground.
8. Start the engine again and operate the plow in
its full range of movement.
9. Shut off the engine and check for leaks.
38