– Store fuel in an approved container and keep
it out of the reach of children.
•
Fuel is harmful or fatal if swallowed. Long-term
exposure to vapors can cause serious injury and
illness.
– Avoid prolonged breathing of vapors.
– Keep your hands and face away from the
nozzle and the fuel-tank opening.
– Keep fuel away from your eyes and skin.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Do not fill containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place
containers on the ground, away from your vehicle
before filling.
•
Remove the equipment from the truck or trailer
and refuel it while it is on the ground. If this is not
possible, then refuel from a portable container
rather than a fuel-dispenser nozzle.
•
Do not operate the machine without the entire
exhaust system in place and in proper working
condition.
•
Keep the fuel-dispenser nozzle in contact with
the rim of the fuel tank or container opening at
all times until fueling is complete. Do not use a
nozzle lock-open device.
•
If you spill fuel on your clothing, change your
clothing immediately. Wipe up any fuel that spills.
•
Never overfill the fuel tank. Replace the fuel cap
and tighten it securely.
Adding Fuel
•
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 86 or higher ((R+M)/2 rating method).
•
Do not
use gasoline containing methanol.
•
Do not
store fuel either in the fuel tank or fuel
containers over the summer unless you use a fuel
stabilizer.
•
Do not
add oil to gasoline.
Using Stabilizer/Conditioner
Use fuel stabilizer/conditioner in the machine to keep
the fuel fresh longer when used as directed by the
fuel-stabilizer manufacturer.
Important:
Do not use fuel additives containing
methanol or ethanol.
Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer.
Filling the Fuel Tank
Capacity:
6.1 L (1.6 US gallons)
1.
Park the machine on a level surface, move the
motion-control levers to the N
EUTRAL
position,
disconnect the kill cord from the operator
presence sensor to shut off the engine, wait for
all moving parts to stop, and remove the key.
2.
Clean around the fuel-tank cap and remove it.
3.
Fill the fuel tank to the top of the filter screen
(
Note:
Do not fill above the top of the filter
screen. The empty space in the tank allows the
fuel to expand.
g295391
Figure 11
1.
Maximum fuel level
4.
Install the fuel-tank cap securely.
5.
Wipe up any spilled fuel.
13
Содержание Snowrator SNR24001
Страница 24: ...g294661 g294662 Figure 29 1 Front tie down point left side shown 2 Rear tie down points 24...
Страница 45: ...Notes...
Страница 46: ...Notes...
Страница 48: ......