Bosch Plena Power Amplifier, Руководство по эксплуатации, Страница: 30 / 192

Fireman’s Panel
Plena Fireman's Panel
EMG mic
Fault Indicators
Processor reset
Network
Call/EMG
Music/Spare
Ground short
Input
A
B
A
B
A
B
Zone1
Zone2
Zone3
Disable
For service only
On 1
2
Termination
RCP ID
Controller
Monitoring
Speaker Warning
This apparatus must be earthed
Trigger Output
24V
DC In N
C
N
O
C
O
M
Call Fault EMG
3 2 1
Power
N
C
N
O
C
O
M
N
C
N
O
C
O
M
EMG.
Mic
Monitor
Off
On
Off
Firmware
Upgrade
Emergency
Acknowledge
Emergency
Reset
Fault
Acknowledge
Fault Reset
Emergency
Mains
Battery
Message
EMG mic
RCP
Router
A
B
A
B
A
B
Zone4
Zone5
Zone6
Indicator test
Reserve
Monitor Speaker
Call
Alarm
Message
Design & Quality
The Netherlands
NL-4827HG-10
Plena Voice Alarm System
Fireman's Panel
Max. input power
300mA, 24V DC
S/N.
PLN-V1FP
A035413
Made in China
N663
8900 199 70501
0 dB
-6dB
-20dB
1 2 3 4 5 6 7 8
9
10 12 13 15 11 14 16 17 18 19 20
Figure 3.13: Front and rear views of the fireman’s panel
Overview of the controls, connections and indicators on the fireman’s panel:
1.
Power LED/VU Meter:
A combined power indicator and VU meter. The green power LED is lit if the fireman’s
panel is connected to the power supply. The VU meter indicates the call level: 0 dB (red),
-6 dB, -20 dB (yellow).
2. Emergency button:
A push button to put the system in the emergency state (see section Emergency state,
page 91).
3. Emergency acknowledge:
A push button to acknowledge the emergency state (see section Emergency state, page
91).
4. Emergency reset:
A push button to reset the emergency state (see section Emergency state, page 91).
5. Alarm message button:
A push button to start the default alarm message. This button is only available in the
emergency state (see section Emergency state, page 91).
6. Fault acknowledge:
A push button to acknowledge the fault state (see section Fault State, page 96).
3.10
30 en | System overview Plena
2013.07 | V2.0 | Installation and Operation manual Bosch Security Systems B.V.