BinTec elmeg hybird 120, Справочное руководство

Страница: 77 / 757

Windows
If you are using a Windows PC, you need a terminal program for the serial connection, e.g.
HyperTerminal. Make sure that HyperTerminal was also installed on the PC with the Win-
dows installation. However, you can also use any other terminal program that can be set to
the corresponding parameters (see below).
Proceed as follows to access your device via the serial interface:
(1) Start the terminal program, e. g. HyperTerminal.
(2) Press Return (at least once) after the HyperTerminal window opens.
A window with the login prompt appears. You are now in the SNMP shell of your device.
You can now log in on your device and start the configuration.
Check
If the login prompt does not appear after you press Return several times, the connection to
your device has not been set up successfully.
Therefore, check the COM1 or COM2 settings on your PC.
(1) Click on File ->Properties.
(2) Click Configure in the Connect to tab.
The following settings are necessary:
- Bits per second:
+
- Data bits:
,
- Parity:
.
- Stopbits:
- Flow control:
.
(3) Enter the values and click OK.
(4) Make the following settings in the Settings tab:
- Emulation:
@
(5) Click OK.
The changes to the terminal program settings do not take effect until you disconnect the
connection to your device and then make the connection again.
If you use HyperTerminal, there may be problems with displaying umlauts and other special
characters. If necessary, therefore, set HyperTerminal to
: 3
instead of
@
.
Unix
bintec elmeg GmbH
9 Access and configuration
elmeg hybird 120 / hybird 130 59