Bernal G 501, Руководство пользователя

Страница: 25 / 62

25
GB
6.2 DELETE A RADIO HAND TRANSMITTER
Deleting one hand transmitter:
Activate programming and enter menu C-2 (Delete a hand
transmitter). The drive signals „Wait for the hand transmitter“.
Actuate one of the programmed channels (buttons) of the desi-
red radio hand transmitter until the garage door drive confirms
the deletion.
Further channels on the same „B-WAY“ which may also have
been programmed (e.g. a second channel for a ventilation func-
tion) are deleted automatically.
Repeat the procedure for further „B-WAY“ radio hand transmit-
ters (or further channels on the same device). Finally leave the
programming screen (occurs within about 60 sec. if there is no
action; the garage door drive moves back automatically into
operational readiness).
Deleting all radio hand transmitters:
Activate programming and enter menu C-3. Enter (Delete all
hand transmitters).
Confirm Position „1“ (Delete all hand transmitters) with ENTER:
All programmed channels on all programmed radio hand trans-
mitters will be deleted irrevocably!
Finally leave the programming screen (occurs within about 60
sec. if there is no action; the garage door drive moves back au-
tomatically into operational readiness).
6.3 Replace the battery in radio hand transmitter
Loosen the screw (S) using a suitable tool.
First remove the bottom section of the housing (A) at the lower
end and then the upper end.
Remove the battery (B) from the holder (C) and replace it, while
noting the polarity, by a new battery of the type LR1 (alternative
designations: Lady, MN9100, N).
Place the bottom section of the housing at the upper end (en-
gage the snap-in nose D) and then at the lower end and secure
with a screw (S).
Note the contents of the section „Disposal“.