Bernal G 501, Руководство пользователя

Страница: 27 / 62

27
GB
1. Function ventilation (menu S-1)
Initially move with the drive into the desired door position.
Activate the function in that menu S-1 to „1“ (active) is switched.
Then save the door position:
2. Position ventilation (menu S-2)
Adopt the current door position as the ventilation position in
that menu S-2 to „1“ (adapt) is switched. Then set up or switch
off the automatic closing:
3. Auto-close ventilation (menu S-3)
Definition: The time period which expires between stop in the
„ventilation position“ and the automatic closing of the door.
The hold open time can be set up in 9 stages from 30 min. to
„continuous“. The function is functionally independent of the
function automatic closing (8.3).
Auto-close ventilation may only be used in combination
with additional safety equipment (photocell / contract
safety edge)!
Activate Auto-close ventilation by changing the setting
of S-3 from „continuous“ (closing is only possible based
on a manually triggered radio hand transmitter com-
mand) to the desired value.
7.5.2 FUNCTION RELAY “PK” (menu S-4)
Definition: Allows selection of the relay contact „PK“ to inactive,
continuous (signal) or impulse (signal). For an explanation see
4.7.2.
Change the setup by activating the desired setting in menu S-4.
7.5.3 FUNCTION LIGHT (menu S-5)
Definition: Allows operation of the integral drive light inde-
pendently of the drive function over the display or radio hand
transmitter: after activation the integral drive light remains until
a new operating command „Light“ or Start active (in the latter
case the light ends after the set lighting period).
Alter the setup in menu S-5 to „active“ if the function is desired.
For actuation over the radio hand transmitter it is necessary to
programme one channel of the radio hand transmitter in additi-
on to „Light“ (see 6.1)!
! PROFESSIONAL EXTENSIONS !