Bender ATICS Series, Руководство пользователя, Страница: 85 / 104

ATICS-DIO_D00080_03_M_XXEN / 04.2021 85
ATICS-…-DIO
Error code/service
code Description Action
3.50 Service alarm has been reset. Only displayed
in the service logger menu. • No action required.
6.xx, 7.xx, 8.1x Device error. The internal self monitoring of
the device has detected a fault which could
impair the safe operation of the device. • Replace device immediately.
8.51 … 8.52 Fault internal power supply unit. • RESET -> execute alarm, then test
the changeover function.
• If fault persists: device replacement.
• Only use test set-ups that provide
the necessary peak current of 17 A.
8.61 … 8.66 Fault during changeover process. Occurs
when the voltage on the new line fails dur-
ing the changeover. Also occurs when the
test set-ups do not supply sufficient current
for switching the coils of the ATICS®.
Can also be caused by missing or improperly
installed bridge on the output side.
The fault can also be caused by an (imper-
missible) connection between GND, k or l
and PE. • Check connection of the bridge
on the output side, if necessary,
re-tighten screws.
• RESET -> execute alarm, then test
the changeover function.
• If fault persists: device replacement.
• Only use test set-ups that provide
the necessary peak current of 17 A.
• In the settings menu 1: Select
changeover t(0) ≥ 160 ms.
• Delete this connection
If there is an error, proceed as follows:
1. If required, enable manual mode.
2. Note down what happened before the error: Operating steps, error messages of the device,
environmental conditions, etc.
3. Have the article and serial number of the device at hand.
4. Contact the Bender service and state the type of error and the three-digit error code.