Bender ATICS Series, Руководство пользователя, Страница: 48 / 104

48 ATICS-DIO_D00080_03_M_XXEN / 04.2021
Commissioning, settings and testing
• As part of the response delay (to be custom-set), you must, at the very least, take into account
the periods of time when the circuit experiences short interruptions, and the response times
of the short-circuit protection equipment upstream or downstream. Regardless of this, a
switchover pause corresponding to the installation location should be taken into account, in
order to avoid switching overvoltages.
Setting: Response delay t(on), dead time t(0) and return transfer delay time t(2->1).
The factory settings and system-specific settings of the ATICS® transfer switching device are document-
ed in the checklist. Please carry out all the work outlined in the list and log each test step.
Keep the checklist with this manual in the vicinity of the device.
5.3 Addressing examples
i
Use terminating resistors correctly
Communication via the BMS bus is only guaranteed when there is a terminating resistor at the be-
ginning and at the end of the BMS bus. Other terminating resistors cause malfunction and must not
be used. Please note the information in the "BMS bus" manual.
An automatic transfer switching and monitoring device with two MK…
Device Parameter Address settings for an automatic transfer switching device
ATICS® Bus address 3
MK… Address 1
Alarm address 3, 2*
MK… Address 2
Alarm address 3, 1*
* These alarm addresses are used for mutual monitoring of the MK… or TM… for device failure.