Bender ATICS Series, Руководство пользователя, Страница: 74 / 104

74 ATICS-DIO_D00080_03_M_XXEN / 04.2021
Menu mode: Operation and setting
i
The reminders for the test (7. Test interval) or the service (8. Serviceinterv) are always triggered at
12:00 pm. If these messages appear at night, the time is set incorrectly on the device.
7.3.4.5 Settings menu 5: Dig. input
In this menu, you can adjust settings for the mode of operation and function of the digital inputs. The
digital inputs are galvanically separated. They are designed for an input signal of AC/DC 24 V.
For each input, selection is possible when the input is set to: "24V" (high) or "0V" (low). In the "24V" set-
ting, the selected function (e.g. alarm message) is carried out when there are 24 volts there. In the "0V"
setting, the selected function is carried out when there are 0 volts there. It is for this reason that you
should always set unused digital inputs to "off".
Select digital input:
1. Use the " " arrow button to go to the digital input setting. Press the " " button.
2. Use the arrow buttons to select one digital input (e.g. Dig. input 3) or all four digital inputs
(Dig. input 1…4). Press the " " button to confirm your selection.
Setting one digital input Setting all digital inputs
i
By selecting the function of the digital input, the recommended response value is automatically ad-
justed:
- Test, M/A,1, 0, 2 (switch positions)
24V (cannot be changed)
- no2->1, 1<->2, bypass, alarm and R-OPL 0 V (can be changed)
The "Bypass" setting can only be changed temporarily for test purposes. After restarting the ATICS®
this setting returns to "0V"!