baxter Colleague 3 CXE, Руководство оператора

Страница: 69 / 230

071960491 COLLEAGUE CXE VOLUMETRIC INFUSION PUMP OPERATOR’S MANUAL
4-15
Operating Instructions
Replacing the Primary Infusion Container (Using the Same
Replacing the Primary Infusion Container (Using the Same
Administration Set)
1.
If the pump module is running, press the
STOP
key on the pump
module to stop it.
2.
Close the regulating clamp on the administration set.
3.
Unload the administration set from the pump module (see
“Unloading the Administration Set,” 4-70) and detach the
administration set from the empty infusion container.
4.
Attach the administration set to the new infusion container and
follow the instructions for "Preparing the Primary Infusion Container
and Set" starting at step 2 on page 4-14.
Recommended Administration Sets
! WARNING !
Laying the infusion source container flat during an infusion increases the
potential for air to enter the tubing, resulting in an Air in Line alarm and
interruption of patient therapy.
! WARNING !
Use only Baxter standard administration sets equipped with keyed slide clamps
that are labeled as being COLLEAGUE pump compatible or denoted with an “s” in
the product code. If you have questions about administration set compatibility,
contact the Baxter Product Information Center at the number shown on the
administration set labeling. Using anything other than the recommended
administration sets with this pump will result in operation that is not within the
constraints and parameters of the device.
Severe injury or death may result from using sets other than those approved by
Baxter Healthcare Corporation for use with COLLEAGUE pumps. Always read and
follow the instructions in the Operator’s Manual and those accompanying the set
and source container.