Barudan BEVT Series, Инструкция по эксплуатации

Страница: 188 / 193

Adjusting the Position Finger
1. Remove the throat plate.
2. Rotate the hand wheel until the needle reaches the lowest position, the bottom of its
stroke.
3. Loosen the screw slightly, taking care to use the correct size screwdriver since the
screw is very flat and easily stripped.
4. Carefully move the position finger, centering the nose to the needle. To make sure that
the needle is being looked at the needle straight on, use the lubrication hole, behind the
throat plate, as a reference. Visually line up the needle with this hole, then adjust the
position finger.
It is very critical that there is a gap between the nose and hook assembly. This gap
should be approximately .5-.75mm to allow the bobbin and top thread to pass through
this gap. Too small a gap will cause bird nesting and thread breaks.
5. Carefully re-tighten the screw.
Checking Needle Depth Manually
1. Make sure the sewing head is at Needle #1.
2. Power down the machine.
3. Open the bobbin case.
4. Remove the back center cover to gain access to the main pulley degree wheel.
5. Rotate the main pulley to where the needle is at it’s lowest point. The indicator on the
pulley should be at 0 degrees.
BE
V
T Series
Mechanical
Guide Troubleshooting
3
-
7