![background image](http://html1.mh-extra.com/html/barco/overview-cdg67-dl/overview-cdg67-dl_installation-manual_4192338080.webp)
6. Final Adjustment and Configuration
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
______________________________________________________________
6-20
The dimmer will be positioned immediately after entering a new target value, and the related DIS value is
adjusted accordingly.
Due to the fact that the lamps show tolerances in burner position and arc length, multiple lamps with the
identical relative brightness value will show differences in emitted brightness. This can be checked by reading
out the value of the direct illumination sensor (
DIS
).
In relative mode, values can be entered in the range from 50 to 100 (50% to 100%).
To modify the light level:
•
Use the cursor keys to set the focus to the
Value
text field.
•
Press
Enter
to activate.
•
Use the left/right cursor key to decrease/increase the value, or set a new value by means of the numeric
keys on the Remote-Control unit.
Since it is the result of the measurement, the
DIS
value cannot be modified, it is read-only.
Set Brightness, Absolute (controlled mode)
Figure 6-25
Dialog box Set Brightness, absolute mode activated
It is recommended first to run DIS calibration, cf.
Error! Reference source not found
Error! Reference source not found
Error! Reference source not found
Error! Reference source not found....!
In this operation mode, the dimmer is positioned by the brightness control algorithm utilizing the readout level
of the direct illumination sensor
DIS
as feedback signal.
The control loop is triggered each time a new target value is entered. It also becomes active after change of
mode from
relative
to
absolute
. The control loop stops once the target value is reached within an accuracy limit
of
±
1%. Typically this takes about 10 sec.
The target value is in same units as the
DIS
value. If the
DIS
is calibrated to lux by appropriate setting of the
DIS
calibration factor
, then the target value is to be entered in lux.
If the dimmer fails to reach the target brightness because it is operated at it’s upper or
lower limits an error message will show up.