5. Geometric adjustment
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
________________________________________________________________
5-1
5.15
Installing the shielding
SLD01
Start mounting the side and top shielding.
Don't forget to remove the sealing of the
double sided tape which is already on the
shielding
Use the nippled hammer bolts (B361304) and
spring washers to assure proper grounding.
All shieldings are fixed on the corner brackets
with the drive fastener.
In case coated material is fixed with
In case coated material is fixed with
In case coated material is fixed with
In case coated material is fixed with
ha
ha
ha
ham
m
m
mmer bolts to the profile: Make sure to
mer bolts to the profile: Make sure to
mer bolts to the profile: Make sure to
mer bolts to the profile: Make sure to
use the
use the
use the
use the nippled hammer bolts and spring
nippled hammer bolts and spring
nippled hammer bolts and spring
nippled hammer bolts and spring
was
was
was
wash
h
h
hers to provide proper groun
ers to provide proper groun
ers to provide proper groun
ers to provide proper ground
dd
ding
ing
ing
ing.
SLD02
The rear shielding is mounted in the following
way: start with the engine shielding, proceed
with the mirror shielding and end with the top
rear shielding. The engine shielding is fixed by
sliding it downwards onto the 30/60 profile.
When the mirror shielding is placed, loosen the
screws of the exhaust pipe and make sure to
lower the exhaust pipe to a maximum and
tighten the screws. Finish by placing the profile
caps and the nut caps.
Complete the mirror shielding by attaching the
Barco label on the respective rectangle
(125mmx125mm) on the plastic mirror cover.
