6. Final Adjustment and Configuration
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
________________________________________________________________
6-2
6.2.1
Terminology of RCU controls
1
Function keys
have no function for this projector
2
ADJ
ADJUST key, to enter or exit the adjustment mode.
3
Address key
(recessed key), to enter the address of the projector (between 0 and 9). Press the
recessed address key with a pencil, followed by pressing one digit button
between 0 and 9.
4
Selection key
has no function for this projector
5
PAUSE
has no function for this projector
6
Standby
stand by button, to start projector when the power switch is switched on and to
switch off the projector without switching off the power switch.
7
Mute
has no function for this projector
8
Help
has no function for this projector
9
Digit buttons
To enter the remote control address
10
Audio controls
have no function for this projector
11
Picture controls
Except for brightness and contrast, these keys have no function for this projector.
The controls of brightness and contrast are only enabled in case the optical
dimmer is disabled, cf.
Error! Reference source not found.
Error! Reference source not found.
Error! Reference source not found.
Error! Reference source not found.
12
PHASE
has no function for this projector
13
Freeze
has no function for this projector
14
TEXT
has no function for this projector
15
ENTER
to start up the adjustment mode or to confirm an adjustment or selection in the
adjustment mode.
16
Cursor Keys
to make menu selections when in the adjustment mode.
RCU
cursor key up
cursor key down
cursor key right
cursor key left
Use the cursor keys up or right for increasing a value.
Use the cursor keys down or left for decreasing a value.
17
EXIT
to leave the adjustment mode or to scroll upwards when in the adjustment mode.
18
RC operating
indication
lights up when a button on the remote control is pressed. (This is a visual indicator
to check the operation of the remote control)
