Barco Led Pro, Руководство пользователя

Страница: 42 / 186

28 LED-PRO • User’s Guide
4. Operation
Power-Up Initialization
During this process, the following message is shown:
Figure 4-6. Initialization Screen — Set IP Address
At the conclusion of the boot-up procedure, the Input 1 button will light and the Status
Menu is shown.
_ççíìé=ïáíÜ=~=píçêÉÇ=ildl
During your last session, if a LOGO was stored in non-volatile memory, it will be loaded into
memory during initialization. During the loading process, the following message is shown
along with a progress bar (on the third line):
Figure 4-7. Initialization Screen — Load Logo
At the conclusion of the procedure, the Input 1 button light and the Status Menu is shown.
S e t t i n g E t h e r n e t
w i t h s t a t i c I P a d d r
P l e a s e w a i t . . .
Note It takes approximately 40 seconds for the system to set the IP
address.
Note By default, LED-PRO boots up with Input 1 selected from a
“factory reset” operation. However, if you perform the “ Save
System State ” procedure with a different input selected, the
system will acquire and select that input.
L o a d i n g L o g o
P l e a s e w a i t . . .
Note By default, LED-PRO boots up with Input 1 selected from a
“factory reset” operation. However, if you perform the “ Save
System State ” procedure with a different input selected, the
system will acquire and select that input.