Barco Led Pro, Руководство пользователя

Страница: 41 / 186

LED-PRO • User’s Guide 27
4. Operation
Power-Up Initialization
•
Initialization Screen 3 displays the software version that is currently being
loaded. Note that the software version changes as upgrades are released.
Figure 4-3. Initialization Screen 3
At the conclusion of the boot-up procedure, the Input 1 button will light and the Status
Menu is shown:
Figure 4-4. Status Menu (sample)
Refer to the “ Using the Status Menu ” section on page 36 for complete details.
_ççíìé=áå=bíÜÉêåÉí=jçÇÉ
If Ethernet mode was enabled (on the Ethernet Menu ) and saved during your last session,
it will be restored during initialization.
•
If DHCP was enabled, LED-PRO will attempt to contact the DHCP server for an IP
address. During this process, the following message is shown:
Figure 4-5. Initialization Screen — Connect to DHCP Server
•
If DHCP is off and a static IP address was saved (e.g., any address other than
000.000.000.000 ), LED-PRO sets the Ethernet port with the selected address.
L E D - P R O
B a r c o F o l s o m L L C
V e r s i o n 2 . 0 0
I n i t i a l i z i n g . . .
I N :
1 0 2 4 x 7 6 8 @ 5 9 . 9 4
O U T : F r e e r u n
W a l l : E n a b l e d
Note By default, LED-PRO boots up with Input 1 selected from a
“factory reset” operation. However, if you perform the “ Save
System State ” procedure with a different input selected, the
system will acquire and select that input.
S e a r c h i n g f o r
D H C P s e r v e r
P l e a s e w a i t . . .
Note It takes approximately 40 seconds for the system to connect
to the DHCP server.