Barco Eos, Руководство пользователя

Страница: 85 / 170

4. Operating
Barco – Eos Workstation for Windows – DOC-3062-2 – Revision 12 – August-2004
__________________________________________________________________________
4-22
Stream
A list of all video streams in alphabetic order
Decoder Control
IP Address
IP address of the encoder; this can be a unicast, broadcast or multicast address.
Port
Encoder port, appendant to the IP address.
IP Portocol
Selection of the used IP protocol; currently only UDP is supported
Stream Protocol auto
Auto-detection of the stream type
elementary
Elementary MPEG-2 stream
program
Program MPEG-2 stream
transport
Transport MPEG-2 stream
PID
Should be entered for transport streams and if the PAT (program allocation tables) or
PMT (program map tables) is not sent.
0 is a predefined value. It causes an auto-search for the video PID. If no valid PID is found
no video will be shown.
Skip bytes at …
Start
End
Encoder dependant value of the number of bytes that must be skipped at the beginning
/ end of each packet, please see table below.
Encoder Control
This section contains data that is used, if initial communication with the encoder is
needed to prompt the encoder to send a stream. All fields must be filled in!
IP Address
IP address of the encoder; may only be filled in if TCP has been selected for IP Portocol
Port
Port where the encoder listens to TCP start commands; may only be filled in if TCP has
been selected for IP Protocol
IP Protocol
Should remain udp , as indicated in the section Decoder control above. Only if a commu-
nication with the encoder is required, tcp should be selected.
Startstring
String that is sent to the specified encoder
Figure 4-9
Parameters on the Streams Parameters Editor
As unicast streams are only sent to one single IP address, only one Streaming Video Card at
a time is able to display one particular unicast stream.