B&R ACOPOSinverter P84, Руководство пользователя

Страница: 333 / 405

Programming guidelines
ACOPOSinverter P84 User's Manual 2.10 333
2.8.22 [CONNECT MULTI-POINT]
It is possible to communicate between a graphics terminal and several inverters connected to the same bus. The
addresses of the inverter must be configured in advance in the menu [COMMUNICATION] via the parameter
[Address Modbus] (Add) .
If several converters are connected to the same graphic display terminal, this automatically displays the following
screens:
ESTABLISHING CONNECTION
Vxxxxxx
Address 1
Address 2
Address 3
Address 4
Address 5
Address 6
ADDRESS MULTIPOINT
CONNECT MULTI-POINT
Rdy 0 Rpm 0 A
NLP +1500 Rpm 1,250 A
Not connected
Rdy +0 Rpm 0 A
RUN +952 Rpm 101 A
2
4
5
6
3
HOME T/K
RUN +952 Rpm 101 A 3
Motor speed
Motor current
+952 rpm
101 A
ENT
ESC
Cfg Add
ESC
ENT
Drive selection for data exchange via multi-point connections
(select the individual addresses and highlight these by pressing
ENT).
This screen is used only when you first switch on the inverter, or
if the function key Cfg on the screen CONNECTION MULTI-POINT
is pressed (see below).
Selection of a inverter for the
data exchange via a multi-point
In multi-point mode, the command channel is not displayed. The
status is first displayed, then the two selected parameters and
then the inverter address (from left to right).
Cfg Add
All menus can be accessed in the multi-point mode. Only the control of the inverter via the graphic display
terminal is not permitted, with the exception of the stop button, that locks all inverters.
In the event of a fault the display is positioned on this.