Balcrank Fusion 3110-027, Сервисный бюллетень

Страница: 46 / 60

Adding Hoses
46
After adding a keypad, you can add hoses associated with it. You can also enter hoses not associated with any keypad. You can drag and drop hoses to
a keypad or between keypads in the system tree.
To add hoses:
1� Click New Hose �
2� Enter the hose ID�
NOTE: Do NOT change the Prefix!
3. Enter the hose Address. This is found on the label on the meter.
4. Enter the Tank the fluid will be dispensed from.
5. Enter the dispenser Units of measure of the meter.
6. Enter the dispense keypad the hose is attached to. To leave the hose
unassigned, select the empty entry in the drop down list. The hose must be
assigned before it can be used.
7� Click Save � The new hose will appear on the Keypad and Hoses system
tree under the assigned keypad, and the New Hose screen will reset for
another new hose�
8. Once all hoses have been added, click Close �
NOTE: If a hose is added without an assigned dispense keypad, it appears under Unattached Hoses. Hoses not assigned to a dispense keypad do not
appear on the Initialization screen�
Edit a Hose
1� Select the hose you would like to edit�
2� Click
Edit
�
3. In the Edit Hose screen, make any changes following the same steps listed
in “Adding Hoses”.
4� Click
Save
to save changes or click
Close
to exit the screen without
saving changes�
Use these steps to assign unattached hoses to a keypad as well�
To delete a hose, select it on the left and click
Delete.