Baby Lock Meridian 2, Инструкция и справочник

Страница: 81 / 132

MAKING EMBROIDERY ADJUSTMENTS
79
AD
V
A
NC
ED EMBR
OI
DE
R
Y
3

Bobbin Thread Is Too Tight
Upper thread on the right side of fabric seems to be lifting/
looping and bobbin thread is not seen on the wrong side
of fabric.
If this occurs, turn the slotted screw (-) counterclockwise,
being careful not to over-loosen the screw, approximately
30-45 degrees to decrease bobbin tension.
Using the Automatic Thread Cutting
Function (End Color Trim)
The automatic thread cutting function will cut the
thread at the end of embroidering each color. This function is
initially turned ON. To turn this function OFF, touch and
then .
* This setting returns to its default when the
machine is turned off.
a
Touch .
b
Touch to turn off the automatic thread cutting
function.

The key will display as . When one color
thread is embroidered, the machine will stop without
cutting the thread.
1
Right side
2
Wrong side
IMPORTANT
• DO NOT adjust the position of the phillips (+)
screw on the bobbin case as this may result in
damage to the bobbin case, rendering it
unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.
Note
• When adjusting the bobbin case, be sure to
remove the bobbin from the bobbin case.