22
07 - 2009
This connection is for the optic sensors that measure the level of coins present in the hopper,
they detect the Minimum and Maximum levels of coins in the hopper. The position is
configurable to adapt to the capacity levels and the storage needs .
Connection programming and tools.
This connection is for programming the firmware of the T3 hopper. The circuit board is governed
by a micro-controller with a flash memory that allows one to update the firmware by means of
the user tools. For this operation there is the web technical of Azkoyen Medios of Pago, S.A
with the application HeUs.
For reprogramming in the field you may use, in combination with the application HeUs, the
portable tool TL20.
The specification for this 6-pin connector is the following:
Pin
Function
1 -
2 GND
3 RX
4 -
5 TX
6 +5V
Table 12: Pin out of the programming connector
Configuration Dipswitches for Cctalk addresses and working modes
The dipswitches are used for the configuration of the Cctalk address, if necessary, they can be
changed manually. Additionally, they may be configured by means of the main connector of the
unit or with Cctalk commands.
The functions of the dipswitches are:
Table 13: Function of dipswitches in ccTalk
