6
07 - 2009
2
INSTALLATION AND STARTING UP
For correct installation and starting up, the following points must be checked:
1)
Be sure that the model of Hopper corresponds with the type of interface in the
machine or system, that is, if it works in parallel or with serial communication Cctalk
®
. This information is available on the label of the hopper, as shown in figure 2.
Figure 1: label with the characteristics
2)
Disconnect the machine or system from the mains power supply.
3)
Check the position and the type of connector in the machine, to determine if the T3
hopper connecter should be fitted at the front or back. The position of the main
connector on the T3 may be changed with a simple operation.
4)
Be sure the type of coin that is to be paid out from the hopper corresponds with the
configuration of the hopper. There are different track configurations for the
Model
T3 HOPPER CCT/CM/EU
Reference 411xxxx-x
Interface CCTALK®
Connector Position
STANDARD
Coinage
Ø18- Ø26 (2c to 2€)
Program €
Date 04/09/09
ATTENTION: Is very important carry out the
installation of the T3 hopper with the machine
disconnected from the mains to avoid producing
any electrical damage.
