1
z
LCD, REFLECTIVE OR TRANSMISSIVE WITH YELLOW/GREEN
OR RED LED BACKLIGHTING (9-28 VDC power supply required for
versions with LED backlighting)
z
0.35" (8.90 mm) HIGH DIGITS
z
REPLACEABLE INTERNAL LITHIUM BATTERY PROVIDES UP TO
7 YEARS OF UNINTERRUPTED OPERATION
z
NEMA 4X/IP65 SEALED FRONT BEZEL
z
COUNT SPEEDS UP TO 10 KHz (CUB70)
z
COUNT INPUT FROM 10 to 300 VAC/DC (CUB7W)
z
WIRE CONNECTION MADE VIA SCREW CLAMP TYPE
TERMINALS
z
FITS DIN STANDARD CUT-OUT 1.77" (45 mm) x 0.874"
(22.2 mm)
DESCRIPTION
The CUB7 series is an 8-digit miniature counter with large 0.35 inch (8.90
mm) high digits. It has an LCD read-out available in Positive Image Reflective,
Negative Image Transmissive with yellow/green backlighting or red
backlighting. The backlight versions require an external 9 to 28 VDC power
supply.
The CUB7 series use a CMOS LSI counter circuit chip, mounted on a gold-
plated substrate, that is electrically connected by ultrasonic wire-bonding.
Proven micro-electronic assembly and manufacturing techniques provide these
units with the reliability and dependability required for industrial service.
The CUB7 series is housed in a lightweight, high impact plastic case with a
clear viewing window. The sealed front panel with the silicone rubber reset
button meets NEMA 4X/IP65 specifications for wash-down and/or dusty
environments, when properly installed.
SAFETY SUMMARY
All safety related regulations, local codes and instructions that appear in the
manual or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Do not use this unit to directly command motors, valves, or other actuators
not equipped with safeguards. To do so, can be potentially harmful to persons
or equipment in the event of a fault to the unit.
SPECIFICATIONS
1.
DISPLAY:
8-digit LCD, 0.35" (8.90 mm) high digits.
2.
POWER SOURCE:
Replaceable Internal 3.0 V lithium battery to provide
up to 7 years of continuous operation. (Battery life is dependent upon usage.
Count and reset contacts that remain closed for long periods of time reduce
battery life.)
3.
BACKLIGHT POWER REQUIREMENTS:
9 to 28 VDC; 35 mA. typical,
50 mA max. Above 26 VDC, derate max. operating temperature to 40°C.
Must use a Class 2 or SELV rated power supply for CUB70.
4.
INPUTS
All: V
IL
(low) = 0.5 V max
Low speed input (CUB70): 30 Hz from switch contact or open collector
transistor with 50% duty cycle
Low speed input (CUB7W): 10 to 300 VAC/DC, 50/60 Hz, 30 cps max.
150 V max for backlight versions. Unit counts on positive going edge.
Note
: For Triac inputs, use the standard CUB70 with a TCM module.
High speed input (CUB70) V
IH
(high) = 2.0 V min. (3 V max). 10KHz
max from 3.0 V bipolar output with a 50% duty cycle
5.
REMOTE RESET:
15 msec min. pulse width (active low) from 3.0 V
bipolar output, an open collector transistor, or a switch contact to common.
6.
ENVIRONMENTAL CONDITIONS:
Operating Temperature Range
: 0 to 50°C Derate max. operating
temperature to 40°C above 26 VDC. (Backlight versions)
Storage Temperature Range
: -30 to 80°C
Operating and Storage Humidity
: 85% max. (non-condensing) from 0°C to
50°C.
Altitude
: Up to 2000 meters
MODEL CUB70 & CUB7W - MINIATURE ELECTRONIC 8 DIGIT COUNTER
DIMENSIONS In inches (mm)
Note: Recommended minimum clearance (behind the panel) for mounting
clip installation is 2.15" (54.6) H x 3.00" (76.2) W.
PANEL CUT-OUT
CAUTION: Risk of Danger.
Read complete instructions prior to
installation and operation of the unit.
Bulletin No. CUB7/7W-X
Drawing No. LP0601
Released 07/05
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
