Avocent AV Works, Инструкция по установке и эксплуатации

Страница: 67 / 144

Chapter 5: Serial Console Viewer 55
3. Enable or disable the Automate Login checkbox. The default value is enabled. When automatic
login is enabled, the login script must contain Success and Failure strings.
4. Click OK to exit the dialog box and save any changes.
-or-
Click
Cancel to exit the dialog box without saving any changes.
To change a default login script:
1. Select Options - Sessions Properties from the Serial Console Viewer menu.
-or-
Click the
Session Settings icon in the toolbar.
2. Click the Login Scripts tab.
3. In the Default Login Timeout field, enter the number of seconds the Serial Console Viewer
will wait for a valid response to automatic login information, in the range 1-99999. The default
value is 30 seconds.
4. In the Initial Character pull-down menu, select: CR (carriage return), CR+LF (carriage return
and linefeed), CR+CR (carriage return and carriage return), ESC (Escape), CTRL+P
(P sequence, 0x10 in hex) or None (no initial transmission character). The default
value is None.
5. In the first Expect field, type the 1-32 alphanumeric character string that you expect from the
unit. Spaces are allowed. Table 5.2 lists the CCM appliance default values.
6. In the first Send field, type the 0-32 alphanumeric character string to be sent in response to the
Expect string. Spaces are allowed, and a blank field is valid. A CR or CR+LF is appended to
the string, based on the New Line Mode - Outbound setting. If a Send field contains an entry,
the Expect field cannot be blank. Table 5.2 lists the CCM appliance default values.
You may use the following macros in the field. AVWorks software will automatically replace
these variables when the login script runs.
Macro
Will be replaced with
%I IP address
%P Port number
%U Username
%W Password
7. Enter additional Expect and Send field entries as needed, to a maximum of four each. Table 5.2
lists the CCM appliance default values.
8. In the Success String field, enter the string that will indicate the login was successful. This
field must contain a value when automatic login is enabled. Table 5.2 lists the CCM appliance
default values.
9. In the Failure String field, enter the string that will indicate the login was unsuccessful. This
field must contain a value when automatic login is enabled. Table 5.2 lists the CCM appliance
default values.