Avocent AV Works, Инструкция по установке и эксплуатации

Страница: 78 / 144

66 AVWorks Installer/User Guide
Right-click on an AutoView 1000R/2000R switch in the Unit list. Select Manage Appliance
from the pop-up menu.
-or-
Select an AutoView 1000R/2000R switch in the Unit list and press
Enter
.
3. If this is the first time the switch has been accessed since its initialization, or if credentials are
not cached for the switch, a username and password prompt displays. (See Managing Cached
Credentials on page 17 for information about credential caching.)
a. Type in your username and password. [If this is the first switch access since initialization
or reinitialization, the default username is
Admin
(case sensitive) with no password.]
b. Click OK .
-or-
Click
Cancel to exit without logging in.
The AVR AMP appears.
To exit the AMP:
Click OK to save any changes and exit the AMP.
-or-
Click
Cancel to exit the AMP without saving any changes.
Viewing Global General Settings
The Global category displays the appliance product type, its serial number and the language the
appliance is currently using.
Viewing and Changing Global Network Settings
The Global - Network subcategory specifies the appliance’s IP address, subnet mask and gateway
(all read-only if BootP is enabled), MAC address (read-only), LAN interface speed and BootP state
(enabled or disabled). The switch name is also displayed. The name is read-only in this sub-
category; you may change the switch name in the SNMP category.
To change global network values:
1. Click the
Settings tab in the AVR AMP.
2. Select the Global - Network subcategory.
3. In the IP Address field, enter the appliance’s address in IP dot notation. The value cannot be a
loopback address or all zeros. This field may be modified only if BootP is disabled.
4. In the Subnet Mask field, enter the appliance’s subnet mask in IP address dot notation. The value
cannot be a loopback address or all zeros. This field may be modified only if BootP is disabled.
5. In the Gateway field, enter the appliance’s gateway address in IP address dot notation. The
value cannot be a loopback address. If there is no gateway address, enter
0.0.0.0
. This field
may only be modified if BootP is disabled.
6. In the LAN Speed field, select a value from the pull-down menu.