Avocent AV Works, Инструкция по установке и эксплуатации

Страница: 96 / 144

84 AVWorks Installer/User Guide
11. In the Subnet Mask field, enter the subnet mask for the PPP connection, in IP dot notation. The
value cannot be a loopback address or all zeros.
12. Click Apply to save any changes without exiting the AMP.
-or-
Click
OK to save any changes and exit the AMP.
-or-
Click
Cancel to exit the AMP without saving any changes.
Configuring Global Authentication Settings
The Global - Authentication subcategory specifies the type and order of the authentication methods
that will be used. If RADIUS authentication will be used, the RADIUS server information is also
specified in this panel.
To change authentication settings:
1. Click the Settings tab in the CCM AMP.
2. Select the Global - Authentication subcategory.
3. To disable all authentication methods, enable the No Authentication checkbox. You cannot
disable all authentication if SSH is enabled; in this case, you should disable SSH in the Global -
Sessions subcategory, then disable all authentication in the Global - Authentications subcategory.
4. To specify one or more authentication methods, enable one or more checkboxes next to
the method.
5. When you specify more than one authentication method, you may change their order in the list.
Select a method and then click one of the Reorder Authentication Methods buttons. Click the up
button to shift the selected method up; click the down button to shift the selected method down.
6. The RADIUS Servers area is valid only if RADIUS is one of the enabled authentication
methods. If RADIUS is enabled, the following information must be set for the primary server;
information for the secondary server is optional.
a.
In the IP Address fields, enter the addresses of the RADIUS servers in IP dot notation.
These values cannot be loopback addresses or all zeros.
b. In the Shared Secret field, enter the 8-24 character strings that will be used to
communicate with the RADIUS servers. These values must also be configured on the
RADIUS servers; see the RADIUS system administrator or documentation for server-
specific configuration information.
c. In the Access Rights Id. fields, enter the attributes that identify the access rights stored on
the RADIUS servers for this appliance. These values must also be configured on the
RADIUS servers; see the RADIUS system administrator or documentation for server-
specific configuration information.
d. In the UDP Port fields, enter the UDP port numbers that will be used to communicate with
the RADIUS servers, in the range 1-65535.