67
IN1- IN6 input polarity
Through this function, the status ( N.O. or N.C. ) of the control panel IN1
IN6 inputs can be set. By default, these
inputs are NC contacts to be connected to GND (see figure). If used, these inputs allow to send the related vocal
and sms message with a priority compared to the control panel. If the operation with NO contacts is to be
programmed, proceed as follows:
Select menu SETTINGS followed by ;
Select POLAR. IN1
IN6 followed by ;
Follow the instructions displayed on the display
Examples of channel 1 input connections. A prepared at the factory, B to be programmed.
Note: If some inputs are not used, it is not necessary to connect them to Gnd or Vdc.
Clock and date
By this function the time and the date set upon switch-on, can be changed
Proceed as follows to change them:
Select menu SETTINGS followed by ;
Select TIME AND DATE followed by ;
Follow the instructions displayed on the display
Settings for telephone exchange
By this function, it is possible to enable the existence of a telephone exchange on the telephone line and to
program the related figure (to 0 to 9) to enter the external line. By default this function is not operational and the
figure to enter the external line is 0. Proceed as follows to change it:
Select menu SETTINGS followed by ;
Select TEL. EXCHANGE followed by ;
Follow the instructions displayed on the display (Y= YES setting under use; N= NO setting cancelled)
User code change
By this function the user code set upon switch-on, can be changed.
Proceed as follows to change it:
Select menu SETTINGS followed by ;
Select USER CODE followed by ;
Follow the instructions displayed on the display
Installer code change
By this function the installer code set upon switch-on, can be changed.
Proceed as follows to change it:
Select menu SETTINGS followed by ;
Select INSTALLER CODE followed by ;
Follow the instructions displayed on the display
A
GND
Channel 1 input
GND
Channel 1 input
B
