56
AF940R Remote control for activation, disactivation and partial activation of the system
The AF940R remote control shown in the picture has the following technical characteristics:
Power supply: two 3V lithium CR2016-type batteries
Current input: 20mA during transmission
Life: 6 months min. (depending on the number of operations)
Operating functions: activation, disactivation, partial
activation of the system and panic alarm
RF features: Am transmission quartzed
at 433.92 MHZ; max. power 10mW
Signal coding: random pre-set 36-bit code
over 68 billion combinations
Working range: over 40 m in free space. 30 m approx. In residential environments
Dimensions: (70 x 36 x 13) mm.
The AF921 control panel allows to store up to 32 AF940R remote controls. To program the remote control, proceed
as follows:
Select menu EXTRAS followed by
;
Select menu REMOTE CONTROLS followed by ;
The first available position REMOTE CONTROL 01 will be displayed, confirm with ;
At this point the remote control functions can be limited by pressing keys 1, 2, 3, 4, 5 and 6 ( the enabled or
disabled function will be displayed );
Confirm the desired configuration by pressing ;
MEM. REM. CTRL 01 will be displayed, insert the desired code and press the RED and GREEN keys of the
control panel to be programmed at the same time. The control panel will confirm programming by emitting a
Beep ;
LABEL REM. CTRL 01 will be displayed, insert the name of the user of the remote control and confirm with ;
After programming the remote controls, press ESC;
Note: the label of each remote control is stored in the event history file each time the related remote control is
operated.
Control panel AF921 allows to delete the stored AF940R remote controls individually. To delete the remote
controls, proceed as follows:
Select menu DEVICES followed by
;
Select menu REMOTE CONTROLS followed by ;
The first available position REMOTE CONTROL 01 will be displayed, confirm with ;
At this point, press key CANC ;
DELETE? will be displayed, confirm with ;
The control panel will emit a beep for confirmation. It will emit three beeps if the procedure has not been
successful.
The AF921 control panel allows to use the black pushbutton of one of the AF940R remote controls stored as
robbery alarm or panic alarm. For programming proceed as follows:
Select menu DEVICES followed by
;
Select menu 24H ROBBERY or 24H PANIC followed by ;
SENSOR will be displayed, confirm with ;
SENSOR INSERT BATTERY will be displayed, press the black pushbutton of the remote control for 10s.
The control panel will emit a beep for confirmation. It will emit three beeps if the procedure has not been
successful.
P2 Grey/red pushbutton
P1 Red
pushbuttonbutton
P4 Black
pushbutton
P3 Green
pushbutton
Led
