50
PROGRAMMING
Before starting to programme, the SIM card must be inserted into the special module as described in section
Internal View . It must be free of limits (PIN and blocks) to allow the automatic operation. After making all
activations according to the wiring diagram shown at the end of the manual, programme the device as follows:
Power the control panel;
Choose the Menu language;
Insert the FACTORY CODE ( 0000 ) followed by ;
Set TIME AND DATE;
Set the USER CODE ( 4/8 characters ) ;
Set the INSTALLER CODE ( 4/8 characters) ; Different from the previous one !
Now the programming menu is entered.
Afterwards, to enter the programming menu, from the stand-by condition, the user or installer code followed by key
must be inserted; to move within the menu arrow keys must be used. As soon as the desired menu is entered,
press
to select it. Then, by proceeding as per the menu search, press
to select the function or setting.
Note : If the PIN of the SIM cannot be removed, set the PIN as 1234 by using any cell phone.
Menu Hierarchy
Note 1: By inserting the user code only the following menus are entered: List, messages, sensors enabling-
disabling, clock/date settings, user code settings. By inserting the installer code all menus are entered.
Note 2: Before starting the programming sequence, delete all data contained in the system memory by proceeding
as indicated in the system reset setting section.
Warning: the suggested menu is intuitive and the operation of keys is similar to the one of cell phones: in the event
of a wrong operation, the control panel signals the error by emitting 3 BEEPS. Each operation can be changed
immediately or afterwards.
Phone Book
Messages
Extras
-
Memory
- Search name
- Search position
-
Vocal messages
-
Exclusion Sensors
- Relay setting
- TC2 setting
- Radio output
- GSM-PSTN line
- Mains failure
- Periodical call
- Sim validity
- Polar. IN1-IN6
- Time and date
- Tel. Exchange
- User code
- Installer code
- antiscanner
- supervision
- Set entry delay
- System reset
Access from the menu with code (see note 1)
Settings
-
Remote controls
- Keyboard Codes
- Alarm Group A
- Alarm Group B
- Alarm Group C
- 24H Panic
- 24H Robbery
- 24H Technologic
- Wired inputs
Confirmation key
Scroll keys
ESC
to exit
