66
The telephone dialler communicates with the receiver by sending it a monostable or bistable command. Function
RADIO COMMANDS allows to identify, for each one of the 16 radio channels, the type of command, that is
monostable (detector type) or bistable (remote control type) to be sent from the telephone dialler to the receiver.
Further on, during operation, the commands that the user can send as soon as he/she is in line with the dialler, will
be the following:
Keys pressed on the remote
telephone
Resulted function
n
*
0 #
Receiver n disabled = OFF (where n stands for the number, 1 to 16, of the
radio receivers the system can control). If programmed as bistable, only
(remote control option)
n *
1 #
Receiver n enabled = ON (where n stands for the number, 1 to 16, of the
radio receivers the system can control).
By default, the operation is of detector type; to change it and to program the receivers, proceed ad follows
Select menu SETTINGS followed by ;
Select RADIO OUTPUT followed by ;
Follow the instructions displayed on the display
To program receivers, set them in the self-learning mode (according to the related instructions shown in the specific
instructions for use) and press key
.
Power failure or repowering
Through this function, transmission of technical message POWER FAILURE can be enabled and the mains and/or
control panel power failure time can be programmed (1 to 99 minutes ). The sms message is sent to all the
numbers associated to that message. By default, this function is not operational and the time is set at 30min.
Proceed as follows to change it:
Select menu SETTINGS followed by ;
Select MAINS FAILURE followed by ;
Follow the instructions displayed on the display (Y= YES setting under use; N= NO setting cancelled)
Periodical call
Through this function, transmission of the PERIODICAL CALL proper operation technical message with
programming of the time between a call and another (1 to 99 hours) can be enabled. The technical message is sent
to all the associated numbers. By default, this function is not operational and the time is set at 24h. Proceed as
follows to change it:
Select menu SETTINGS followed by ;
Select PERIODIC CALL followed by ;
Follow the instructions displayed on the display (Y= YES setting under use; N= NO setting cancelled)
SIM VALIDITY
Through this function, transmission of the SIM EXPIRY technical message with programming of the SIM expiry time
(1 to 99 months) can be enabled. The technical message is sent to all the associated numbers. By default, this
function is not operational and the time is set at 11 months. Proceed as follows to change it:
Select menu SETTINGS followed by ;
Select SIM VALIDITY. followed by ;
Follow the instructions displayed on the display (Y= YES setting under use; N= NO setting cancelled)
