GETTING STARTED
User Manual
12
13
Dwell
To enter auto dwell mode
14
Backup
To enter backup mode
15
PTZ
To control PTZ camera:
Move camera/ZOOM/FOCUS/IRIS/SPEED control
Operation processes with remote controller to control multi-DVR
The device ID of the DVR is 0. When use of remote controller to control single
DVR, it’s not necessarily to reset the device ID, user can do operation directly;
when control multiple DVR with remote controller, please refer to below steps:
Step1: Activate remote controller to control DVR: enable DVR: turn the IR sensor
of the remote controller to the IR receiver that on the front panel, press the
number key 8 twice, then input device ID (Range from: 0-65535; the default
device ID is 0.) with other digital number: 0-9, after that, press ENTER button to
confirm.
Step2: User can check the device ID by enter into System configuration
Basic
configuration
device ID. User also can set other DVRs with the same device ID.
For more convenient to operate, we don’t recommend user to set the device ID
too long.
Step3: Cancel controller to control DVR: turn the IR sensor of the remote
controller to the IR receiver that on the front panel, press the number key 8 twice,
then input the device ID that needs to be cancelled from controlling, press ENTER
button to confirm. After that, the DVR will not be controlled by remote controller.
2.6 Control with Mouse
2.6.1 Connect Mouse
DVR supports USB mouse through the port on the side panel, please refer to Fig 2.4.
Notice: If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse plugs in the USB mouse port on the back of the DVR,
not the front panel port.
2. Try a different mouse
2.6.2 Use Mouse
In Live:
