29
7.2
Changing the batteries
In order to exchange the batteries of your Audionet Metal Remote
Control
RC 2
, first you have to remove the 6 Phillips head screws on the
bottom side.
The battery compartment is to the left side of the circuit board. You need
2 batteries type 'AAA' or 'Micro' with a voltage of 1.5V.
Important
·
While inserting the batteries please mind their orientation. The
correct orientation is printed onto the bottom of the battery
compartment.
7.3
Settings for Audionet DNA 1
Important
·
The Audionet Metal Remote Control
RC 2
is configured to control
the DNA 1 by factory default. You do not have to perform any
additional configurations. For the sake of completeness the following
section explains the correct setup for the DNA 1.
Depending on their type, Audionet (pre-) amplifiers use different system
addresses for their remote control code. A DIP switch on the circuit board
of the Audionet Metal Remote Control
RC 2
selects the desired system
address.
In order to set the system address you first have to open up the remote
control (see section '
Changing the batteries
' on page 29).
Battery compartment
