24
6.2.4 Input selection
Push the
set
key on the front panel once for less than two seconds to enter
the input selection menu. Then select the desired input channel with the
keys
up
and
down
. In the display you see the selected input channel,
channel number and your chosen channel name. Press
set
to actually
switch to the selected channel. Overview of DNA 1 input channels:
No.
Inputs
Signal
see
3 - Overview back
panel on page 9
1
D1
Digital (electrical)
Digital Inputs
IN 1
17
2
D2
Digital (optical)
Digital Inputs
IN 2
16
3
NET
Stream, USB, Internetradio
Network 15 14 13
4
USB
USB Audio In
USB Audio 18
5
AN1
Unbalanced Line/ Phono
Analog Inputs
IN 1
1-2
6
AN2
Unbalanced Line
Analog Inputs
IN 2
1-2
7
AN3
Unbalanced Line
Analog Inputs
IN 3
1-2
The DNA 1 features a soft input selection. During the switching of
inputs, first the volume is stepped down to –80 dB, followed by switching
off the outputs. Now the input section switches to the new input channel.
Afterwards the outputs are switched on again, and finally the volume is
stepped up to its original level.
Note
·
Leave the input selection function by holding down the
set
key
longer than 2 seconds or wait a few seconds.
·
Using the Audionet Metal Remote Control
RC 2
, switch to the next
or previous input channel without using the
Select Input
function
with keys
CH+
and
CH-
.
·
A '*' besides the channel name indicates the input which is dedicated
to the By-Pass Mode (see section
"8.3.5 - By-Pass channel"
on page
38).
