14
5.2.2 Preamplifier output
The DNA 1 is equipped with one pair of RCA preamplifier outputs
PRE
OUT
3 to connect e.g. an additional amplifier or one or two
subwoofers. You can also use the RCA connection
PRE OUT
3 with
high quality cable (e.g. Audionet C100) for bi-amping.
The preamplifier output
PRE OUT
3 is alsways active, unfiltered and
passes the volume control of your DNA 1.
5.2.3 Headphones Socket
A 6.3 mm headphones socket
HEADPHONES
4 is located at the rear of
your DNA 1. The signal at this socket can be switched on and off to
allow the headphones to be plugged in permanently. Switching is easily
done in the system menu, please refer to
"8.3.1 - Headphones" on page
34.
5.3
Other connections
5.3.1 Network, USB, WLAN
The Ethernet port
LAN
15
*
is a standard RJ45 socket for network cables
(Cat-cable, 10/100 Mbit BASE-T).
The WLAN port
WLAN
13 uses a SMA connection to attach the
provided WLAN antenna. With the articulated joint the antenna can be
turned into two directions.
The USB port
USB
14 is a TYPE-A socket (USB 2.0) for external hard
drive, USB sticks etc.
Note
·
We recommend using a wired network connection for best data
transfer rate and to provide high stability in control with our software.
5.3.2 USB Audio
The USB Audio port
USB AUDIO
18 is a mini-USB TYPE-B-socket.
With the USB Audio connection you are able to connect your DNA 1
with a USB cable directly to a PC. Thus you can use your DNA 1 as the
sound device / playback device for your PC. Playback operates in
*
see number in section
"3 - Overview back
panel" on page 10
.
