Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 68 / 146

Back to TOC Back to Section TOC
Next Back
3-39
3
KM699
11. Install the low/reverse shift fork into the
low/reverse clutch dog; then install the shift cam
into the transmission case and engage the shift
fork pawl in the appropriate shift cam groove.
KM700
12. Install the high shift fork into the high clutch
dog; then engage the shift fork pawl into the
appropriate shift cam groove.
13. Install the shift fork shaft making sure that the
shift fork pawls remain engaged in the shift
cam; then install the shift cam stopper ball,
spring, seal/washer, and plug. Tighten to specifi-
cations.
KM619A
14. Install the shift shaft making sure to align the
timing mark between the two marks on the shift
cam.
KM702A
15. Install the two alignment pins, gasket, and trans-
mission case cover and secure with eight cap
screws. Tighten in a crisscross pattern to specifi-
cations.
KM651A
16. Install a spacer washer and the drive bevel gear
on the driveshaft; then while holding the centrif-
ugal clutch housing with an appropriate holder,
secure the bevel gear with a new nut and tighten
to specifications.
KM650
17. Use a center punch to stake the nut to the drive-
shaft.
18. Apply clean engine oil to a new O-ring and
install in the groove of the secondary driven
bevel gear housing; then with the index marks
aligned, install the secondary driven bevel gear
assembly in the transmission case.