Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 47 / 146

3-18
B. Water Pump
C. Stator Coil
D. Trigger Coil
E. Rotor/Flywheel
9. Remove the right crankcase cover (see Section 4
- Water Pump).
10. Remove the trigger coil mounting screws; then
remove the wire set plate.
KM772A
11. Remove the three cap screws securing the stator
coil to the crankcase cover; then remove the sta-
tor coil and trigger coil.
12. Remove the oil-through and spring from the end
of the crankshaft; then hold the rotor/flywheel
with an appropriate holding tool and remove the
flywheel nut and washer.
KM774
13. Install the flywheel puller and crankshaft protec-
tor; then remove the rotor/flywheel. Account for
a key and the starter one-way clutch bearing.
KM775
KM766A
„
NOTE: The starter one-way clutch bearing is
direction oriented and will only function if installed
properly. Note the markings or arrows when
removed.
F. Oil Pump
„
NOTE: Steps 9-13 in the preceding sub-section
must precede this procedure.
14. Remove the rotor/flywheel (see Rotor/Flywheel
in this sub-section).
15. Remove the starter drive gear and place together
with the rotor/flywheel to keep the one-way
clutch bearing intact.
AT THIS POINT
To remove/service the water pump, see section 4.
! CAUTION
Use extreme care to avoid damaging or shorting the
wiring.
AT THIS POINT
To service the stator coil, see Section 5.
AT THIS POINT
To service the trigger coil, see Section 5.
Back to TOC Back to Section TOC
Next Back