Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 58 / 146

3-29
3
KM412
„
NOTE: Increasing the rotations in step 10 will
increase spring tension.
12. Place the recoil starter assembly into position on
the left-side cover; then tighten the cap screws
to specifications.
V-BELT COVER
1. Inspect the bearing for excessive wear, rough or
binding when turning, seal condition, and secure
mounting in the V-belt cover.
„
NOTE: If the bearing is worn excessively, turns
roughly, or bearing seals are loose, the bearings
must be replaced.
KM254
2. Inspect the V-belt cover for cracks, distortion,
and loose alignment pins.
„
NOTE: If the V-belt cover is cracked or distorted
or if the bearing is loose in the cover, the cover
must be replaced.
DRIVE PULLEY
1. Remove the ramp plate from the movable drive
face; then inspect the ramp plate guides and
weight roller for damage or excessive wear.
KM256
2. Inspect the face surfaces of the fixed and mov-
able drive faces for grooving, nicks, or discolor-
ation.
KM394A
3. Inspect the drive pulley collar for wear or dam-
age. Measure the outside diameter of the drive
pulley collar sliding surface. The minimum ser-
vice limit is 26.94 mm (1.06 in.).
KM389
Back to TOC Back to Section TOC
Next Back